|
Hobby Boards’ Inspeed Anemometer is our premium solution for monitoring wind speed and direction. We are confident that you will be pleased with this device.
Contents of kit
- Anemometer with 3 cup rotor masures wind speeds of 3 to 125+ MPH. Rugged Delrin body with bronze and Rulon bushings. Sapphire bearing to minimize wear.
- Wind vane uses Hall effects. Wind direction resolution higher than one degree. Zero dead band - many potentiometer wind vanes have a dead spot of several degrees -this device has no dead band at all. Near-zero friction - since the magnet is not in contact with the Hall sensor, there is no friction from the sensor. Virtually infinite life - unlike potentiometers that wear out, the magnetic Hall sensor is non-contacting and should theoretically last forever.
- Weather-resistant casing protect bearings and electronics.
- 25 feet of exterior grade wire.
- 1-Wire anemometer controller board with screw terminals for easy connection of the device.
- Controller board case
Required but NOT included
- 1-Wire master
- CAT5 cable
- 7-24v DC power supply
- Software to interpret data
Be aware that this unit is not compatible with the previous version of the 1-Wire Wind Instrument.
NOTE: Please be sure to select your 1-Wire connection type. By default, the case comes with a slit on one end, to accommodate wires connected to screw terminals. If you choose to use the RJ45 connectors, Hobby Boards can provide an additional slot for these wires. Because of the additional slots needed, the case will be less water-resistant when RJ45 connectors are used. Please let us know when you place your order.
| Available Options: |
| 1-Wire Connection: |
|
|
