This all-in-one device allows you to measure temperature, humidity, and solar radiation in a single device. Our combination offers a substantial savings over purchasing separate devices. These units can be used to monitor environmental conditions and are an essential part of your total weather station.

We now use the HIH-4021 humidity sensor which has a cover for better sunlight resistance and a condensation filter to help keep the sensor from getting wet from condensation.

You may wish to install these in multiple outdoor locations to monitor conditions for your garden and landscape areas, enabling you to select the plants most suited to the available sunlight. The solar detector detects light in the visible to infrared portion of the spectrum, with peak detection at 850nm and an acceptance angle of 150 degrees.

This is a fully assembled and tested unit. This device comes with dual RJ45 connectors, as well as screw terminals, for easy connection to your 1-Wire network. This device can optionally use external power of 9-24 volts DC. Either our Power Injector or our 6 Channel Hub would provide the needed power.

Note: We have changed the photodiode (solar sensor) on our solar devices due to manufacturer availability. The new sensor has a lower output than our previous sensor, so the peak output will not clip the way our original sensor did. In addition the new sensor fits better in the case, improving weather resistance and increasing the effective acceptance angle. (The photo of our solar sensor still shows the original photodiode; we will update the site shortly with newer photos.)

Cases are available. See Related Products Below