We now have cases available for most of our 1-Wire devices. You can, of course, still make your own - but ours have been custom designed and built to provide a simple, professional finish for your Hobby-Boards devices.

The Humidity/Temp case has been designed to fit our Humidity, Temperature, and Humidity/Temperature devices. It will accomodate our current board design, as well as all previous Humidity/Temperature with RJ-45 devices. (See our case instructions for the fine print on fitting previous versions.)

In addition to providing a clean finish for your device, this case will protect your device from minor dings and mechanical damage. Please note that the case will not offer substantial protection from humid or outdoor environments, and you should consider a spray-on coating to extend the life of your outdoor devices.

If you are ordering this case for an existing unit please specify (in the order comments) what combination of Humidity, Temperature, and Solar you have so that we can provide the correct label.

The case is approximately 2.6"(66mm) x 2.6"(66mm) x 1.1"(28mm).